Refining the animation - Confident walk


The confident, bold walk is the third and last walk segment before the running animation. Here, the character adopts the personality of a celebrity or at least someone from the upper class in a society. The steps are long, knees are swivelled and feet are twisted towards the exterior. The chest is all the way up front, the shoulders are raised and the back is straight with the arms bent and fists clutching, executing an arching motion cycle.  The walk strongly suggests superiority, confidence and boldness. That is the personality I wanted to convey through this walk animation.

 As I have previously said, this animation segment was the best realised one of them all and only required minor changes. The only issue I was able to identify was the simplicity of the walk, the lack of any secondary action. The character’s head was not moving throughout the entire animation segment, fact that made the model look rather stiff or rigid. I have decided to add to the personality of the character by having him nod his head as if saluting (perhaps a crowd), on his left and right. That in return solved both the simplicity issue as well as the lack of secondary action. The head nodding does not come off as distracting either, thus respecting the principles of animation when it comes to secondary actions.

Comments

Post a Comment

Popular posts from this blog

Final research on 'The Animator's Survival Kit' by R. Williams - Part 3

Image
The heel (page 136) ‘The heel is the lead part. The foot is secondary and follows along. The heel leads and the actual foot drags behind and flops forward – but the heel controls it.’ For walks and runs one should keep the heel flat on the ground until the last possible moment before lifting it. That will give the feeling of weight to the animation. There is an illustration that demonstrates this also: The following drawing serves as a guide for a correct heels motion during a ‘normal’ walk: Also setting a tempo:             Weight shift (page 146) ‘The weight shifts from one foot to another in a normal stride. Each time we raise a foot it thrusts the weight of our body forward and to the side over the other foot. And the shoulders mostly oppose the hips and the buttocks.’ As discussed in a previous post, walking represents a series of controlled falls. As a result, the...
Read more

Adding custom attributes and controllers - Part 2 Spine

Image
In a similar fashion to the work I’ve covered last week, this week I have taken care of adding custom attributes and controllers to the upper body. At the end of this work session I had the spine, neck and head of the model rigged. The control shapes were the first to be added. I needed five different controllers affecting five different bones, some independently, some affecting two or more bones at a time. As seen above, these controllers were in order: COM controller (or the Master controller) – This controller serves as the main one: all the other (body) controllers have been linked to it. When moved, the whole body follows. The same is valid for rotation. Hips controller – This controller takes care of the hips movement (or the spine base). When rotated, the pelvis follows the rotation along with the hips. However, the first spine bone should rotate to a degree as well as a result. To get that effect, ‘Parameter Wiring’ has been used: a new Euler XYZ rota...
Read more

Refining the animation - Leisure walk

Image
In the next few blog posts I will be discussing about the problems I have identified in one of my older blog posts (Animation progress status and observed issues) and how I have solved them over the past few weeks. The posts will each be focused on one of the animations separately, starting with the leisure walk animation in this post followed by the sneak, the bold walk and ending with the running animation. I believe that by organising the blog posts in this way will make it easier for me and anybody else to refer back to if necessary, as well as keeping the blog posting constant, tidy and succinct. The leisure walk The issues I have identified last time in this first part of the animation chain were that the walk is rather wobbly and some of the steps are unequal. The seemly unstableness of the model when walking was caused by the excessive movement of specific parts of the body. For example, upon taking a closer look at the first 20 or 30 frames I have noticed that ...
Read more